User manual
4544
NOXON iRadio 310
4. Getting Started
The items enclosed in the packaging box are as follows:
• iRadio 310 unit
• Power adaptor
• Audio cable with 3.5mm jack at both ends
• User manual
Connect the power adaptor to the back of iRadio 310 and plug it into power socket.
Get the network environment ready
• For wired Ethernet
Use an Ethernet cable (RJ45 jack) to connect the LAN ports on iRadio 310 and your
network device. Check if the light indicators on the network device are in appropriate
status.
• For wireless WiFi
Make sure you have setup the wireless network and you have the WEP, WPA or WPA2
security password to activate the connection.
You may also use the WPS (WiFi Protected Setup) function for easy pairing between
the network device and iRadio 310. Check if the light indicators on the network device
are in appropriate status.
Switch it on from iRadio 310.
At the rst time operation, system asks if you want to
start the Setup Wizard. Select YES to continue the
setup. Details of the Setup Wizard can be referred
to Section 5.2.1 below. After choosing NO, the next
screen asks if you would like to run the wizard next
time iRadio 310 is started.
iRadio 310 will automatically connect to the network
that was set before when power on to Internet Radio
again. In case you desire to change the network,
enter System Setting to congure the corresponding
connection. Refer to Section 5.2.1 and 5.2.3.
Press STANDBY or on the remote control to enter standby mode. The time, date and
any active alarm times display on the screen.
Rotate the volume reel or press / on the remote control to adjust the volume.
Rotate the volume reel or press until volume level becomes 0, or direct press to
mute the sound.