Installation Guide

Page 8 of 12
Regulatory Information
3.1 FCC
This device complies with Part 15 of FCC Rules, Operation is Subject to following
two conditions:
1) This device may not cause harmful interference, and
2) (This device must accept any interference received including
interference that cause undesired operation.
Caution: Any changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void user’s authority
to operate the equipment.
This device and its antenna must not be co-located or operation in conjunction
with any other antenna or transmitter except in accordance with FCC’s multi-
transmitter procedures.
IMPORTANT NOTE:
FCC Radiation Exposure Statement; Co-location of this module with other
transmitter that operate simultaneously are required to be evaluated using
the FCC multi-transmitter procedures.
This module complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The device contains an integral antenna hence, the
device must be installed to so that a separation distance of at least 20cm from
all persons.
This module and complies with the safety requirements for portable RF exposure
in accordance with FCC rule part §2.1093 and KDB 447498 D01.
3.2 ISED Canada
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.