Installation Guide
Table Of Contents
Page 12 of 12
3.3.2 Host Product Label
The host product must be labelled with the following information:
"Contains FCC ID: V5A-NOXBLEMOD"
"Contains IC: 25077-NOXBLEMOD"
“This device complies with Part 15 of FCC Rules, Operation is Subject to
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference
that cause undesired operation.”
Important Notice to OEMs: The FCC Part 15 text must go on the Host product
unless the product is too small to support a label with the text on it. It is not
acceptable just to place the text in the user guide.
3.4 E-Labelling
It is possible for the Host product to use e-labelling providing the Host product
supports the requirements of FCC KDB 784748 D02 e labelling and ISED
Canada RSS-Gen, section 4.4.
E-labelling would be applicable for the FCC ID, ISED Canada certification
number and the FCC Part 15 text.
3.5 Changes in Usage Conditions of this Module
This device and its antenna(s) must not be co-located with any other
transmitters except in accordance with FCC and ISED Canada multi-
transmitter product procedures.
If the device is co-located with multiple antennas, the module could be subject
to FCC Class 2 Permissive Change and ISED Canada Class 4 Permissive Change
policy in accordance with FCC KDB 996396 D01 and ISED Canada RSP-100.
In accordance with FCC KDB 996369 D03, section 2.9, test mode configuration
information is available from the Module manufacturer for the Host (OEM)
product manufacturer.
NOTE: For ISED Canada Head/Body to antenna separation only:
In accordance with RSS-102, section 2.5.1, this module is exempt from
Head/Body SAR testing when installed in a host product with a Head/Body to
antenna separation distance of ≥10 mm.
If the module is to be used with a smaller separation distance than the above,
SAR testing must be performed.