Installation Guide

Page 10 of 12
INTEGRATION INFORMATION FOR THE OEM: It is the responsibility of the
OEM / Host product manufacturer to ensure continued compliance to FCC and
ISED Canada certification requirements once the module is integrated into the
Host product. Please refer to FCC KDB 996369 D04 for additional information.
The module is subject to the following FCC rule parts: 15.207, 15.209 and
15.247
3.3 Host Product
3.3.1 Host Product User Guide Information
FCC Compliance
This device complies with Part 15 of FCC Rules, Operation is Subject to
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference
that cause undesired operation.
Caution: Any changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void user s authority
to operate the equipment.
This device and its antenna must not be co-located or operation in conjunction
with any other antenna or transmitter except in accordance with FCC’s multi-
transmitter procedures.
IMPORTANT NOTE:
FCC Radiation Exposure Statement; Co-location of this module with other
transmitter that operate simultaneously are required to be evaluated using
the FCC multi-transmitter procedures.
If the host manufacturer uses the module in a Mobile configuration then the
following text is placed in the host product, user guide:
This device complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment. The device contains an
integral antenna hence, the device must be installed to so that a
separation distance of at least 20cm from all persons.
OR
If the host manufacturer uses the module in a Portable configuration then the
following text is placed in the host product, user guide:
This device complies with the safety requirements for RF
exposure for portable use conditions in accordance with FCC
rule part 2.1093 and KDB 447498 D01.