Manual
9
Nowsonic Autark LED Master II
User manual
GB
www.nowsonic.com
6. 1–10, 11–20, 21–30 and 31–40 buttons
Using the
1–10, 11–20, 21–30 and 31–40 buttons you can choose
the desired channel group which is then controlled via the
R, G, B and
W/D faders: thus, 40 channels in total can be controlled. The LEDs next
to the buttons show the current selection.
7. CHANNEL MODE button
You can choose the desired channel mode for the faders
R, G, B
and W/D via the CHANNEL MODE button (1): the active selection
is shown via the
LEDs above the buttons. You can choose from the
following six modes:
8. RUN MODE button
By pressing the
RUN MODE button you can choose whether the
program which you have selected via the
MAC fader (3) is controlled
automatically or via the music sensitivity. Depending on the selection,
the
LED AUTO or SOUND lights.
9.
BLACK OUT button
Press the
BLACK OUT button to set all channel values temporarily to
0: this means that all controlled slave units are idle (not lit) as long as
you hold this button pressed.
10.
STROBE button
Press this button to activate the Strobe mode: the Strobe effect is
active as long as you hold the button pressed. When the Strobe mode
is active, you can control the Strobe speed via the
STROBE SPEED /
Sensitivity fader (
5) in the range from 1 to 20Hz.
Cabling
The LED Master II allows to control external slave devices via up to 40
channels. Connect the devices as follows:
1) Using the supplied wall power supply, connect the LED Master II
to the mains power and switch the unit on.
2) Connect a standard high quality
XLR audio cable (not supplied)
to the
DMX out socket (female) of the LED Master II.
LED Channel mode Mode description
M1
RGB
Channel 1 = red, channel 2 = green, channel 3 = blue
M2
RGBD
Channel 1 = red, channel 2 = green, channel 3 = blue,
channel 4 = dimmer
M3
RGBW
Channel 1 = red, channel 2 = green, channel 3 = blue,
channel 4 = white
M4
RGBWD
Channel 1 = red, channel 2 = green, channel 3 = blue,
channel 4 = white, channel 5 = dimmer
M5
DRGB
Channel 1 = dimmer, channel 2 = red, channel 3 =
green, channel 4 = blue
M6
DRGBW
Channel 1 = dimmer, channel 2 = red, channel 3 =
green, channel 4 = blue, channel 5 = white