Manual

7
Nowsonic Autark LED Master II
User manual
GB
www.nowsonic.com
Outlets and controls on the rear panel
The following outlets and controls are available on the top panel of
Autark
LED Master II:
1.
DMX OUT socket
Connect a standard
XLR cable (not supplied) to the DMX OUT socket:
The pins of this female
XLR socket are wired as follows:
Wiring
Pin 1: ground (shield)
Pin 2: signal inverted,
DMX -
Pin 3: signal,
DMX+
The signal is output in the
DMX 512 format. You must therefore
connect the cable to a
DMX-capable input of the slave device.
NOTE: The LED Master II works always as the master in any DMX
setup. Therefore, all following DMX devices must be configured
as slave units.
2. DC INPUT socket
Connect the included wall power supply with the
DC INPUT sock-
et (coaxial plug, + = inner contact,- = outer contact). If the supplied
power supply is not available, you can use any
AC adapter as long as it
matches the requirements (9–12V, min. 300mA).
3. POWER switch
The
POWERswitch turns the LED Master II on and off.