Manual

12
Nowsonic Autark LED Master II
User manual
GB
www.nowsonic.com
STROBE mode
The Strobe mode is activated by pressing and holding the
STROBE
button. When you hold the STROBE button, the speed of the Strobe
effect can be set with the
STROBE SPEED fader in the range from 1
to 20Hz.
When the
STROBE button is released, the LED Master II returns to the
previous mode.
Regardless of the current mode, you can press the BLACK OUT button
at any time to temporarily darken all connected lights for the duration
of the button press.
Specications
Type
DMX controller
Data format
DMX
DMX
protocol DMX 512
DMX
channels 40
Channel modes
RGB, RGBD, RGBW, RGBWD, DRGB,
DRGBW
Operating voltage 9–12VDC 300mA (external power supply
included)
DMX connector 3-pin XLR (output)
Weight 0.8 kg
Dimensions 200 × 56 × 110 mm (H × W × D)
Scope of supply

Autark LED Master II: 1 pc

Wall power supply: 1 pc

User manual: 1 pc
Disclaimer
Nowsonic has taken all possible steps to ensure that the information
given here is both correct and complete.
In no event can Nowsonic accept any liability or responsibility for any
loss or damage to the owner of the equipment, any third party, or any
equipment which may result from use of this manual or the equip-
ment which it describes.