Use and Care Manual
IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping. If there is a defect in the
wire, do not attempt installation. Please call the Customer Service Team at 1-800-933-7188.
Package Contents & What You’ll Need
Installation
A
B
C
Part Description QTY
A #18 SJTW 3-Conductor Wire Socket 1
B 1-Button Controller 1
C Use and Care Guide 1
NOTE: Support cable and hardware
not included (sold separately).
Need Extra Bulbs?
Go to shopNovolink.com or call 1-800-933-7188
1
Preparing for installation
□ Disconnect power at the source prior to attempting to install or service the
light string.
□ Use only with 120V AC receptacles.
□ Before powering the string light, inspect bulb and socket.
2
Attaching the Controller to the string light
□ Remove the cap from the 1-button Controller (B), exposing the female
connector. On the string light (A), locate the 3-prong male connector, and join
the two ends. Once connected, secure the connector cap CLOCKWISE into
place over the receiving connector.
□ After inspecting the bulbs, cover the female connector at the end of the light
string set with its cap.
□ Plug-in the 3-prong AC connection to any compatible GFCI outlet. The red
indicator light on the controller will turn on, and all bulbs should light in their
default settings.
3
Suspending the light string
□ The light string must be securely attached to a support structure at
each end of each span.
□ Secure the light string to supporting hardware (eyebolts, brackets,
etc., not included). Use properly rated securing devices, and follow
local codes for suspended structures and loads.
□ Light sockets must be suspended so that bulbs are facing down ONLY.
DO NOT mount the light string with sockets facing upward. Bulbs
should hang freely in a downward direction. DO NOT cluster the bulbs.
□ Plug-in the 3-prong AC connection to any compatible GFCI outlet. The
red indicator light on the controller will turn on, and all bulbs should
light in their default settings.
□ After inspecting the bulbs, cover the female connector at the end of
the light string set with its cap.
NOTE: Avoid damage to the insulation during installation.
DO NOT pierce or otherwise compromise outer covering of
wire or socket, jacket, or sheathing. DO NOT secure light
string to buildings or other structural supports using nails,
staples or other sharp, conducting materials that may
damage the cord.
IMPORTANT: When interconnecting multiple light strings,
prevent the connection from separating. Ensure that the
3-prong connections between strings are bound in place by
the plug caps. Mount the light strings using the keyholes
above each socket, for optimal support. You can also mount
to support cable or use twine or wire to connect the rst
and last sockets via the keyholes at the top of each.
Smartphone or Tablet
with WiFi capability, and an
Apple iOS or Android operating system.
A 2.4GHz WiFi network
WiFi Router
(While this can be any 2.4GHz WiFi
connection, keeping the light string
connected to a specic connection,
such as your home WiFi router, is
recommended.)
Amazon Echo or Google Home
An Amazon Alexa Echo or Google
Home smart speaker is necessary
for voice-control of the lights.
(Compatible with all Amazon Echo
and Google Home units.)
What you’ll need
Package Contents
Up to 5 strings can be
connected to 1 Controller.