Full Product Manual
WARNING:
This string light set is not a toy
- please keep it out of reach of
children. The light set should not be
plugged in while still in the packaging.
The bulbs are not replaceable. For
indoor and outdoor use. Do not
attempt to hard-wire the light set to
another light set. The electric cord
cannot be replaced. Only use the
included IP 44 adapter. Caution:
When connecting the string light to
the adapter, the screw cap must be
rmly tightened. If the adapter and/
or the light(s) are damaged or do not
work properly, the whole unit should
be disposed of in accordance with
local, state and federal regulations.
WARNING - RISK OF ELECTRIC SHOCK.
IF BULBS ARE BROKEN OR MISSING,
DO NOT USE.
1. When connecting an Add-On Set to a
Controller/Transformer Set, the screw
cap must be rmly tightened.
2. The total connected sets may not
exceed the maximum allowed number
of 2 Add-On Sets to a Controller/
Transformer Set. If this limit is
exceeded, it may result in a risk of
electric shock.
3. Ensure that the supply cord and inner
wiring are not subject to mechanical
load/stress.
4. Never hang or mount any object to the
lighting chain.
5. Always disconnect the adapter from the
electrical outlet when the light set is not
in use, or when the area where it is in use
is unattended for long periods of time.
6. For outdoor use, ensure the electrical
outlet or any extension cord is in
compliance with the protection class
IP44 (splash water proof). If there
is any doubt, consult a professional
electrician.
7. Each section of a connected light set
must be mounted individually.
8. Dispose of an entire light set if
any portion of it is mechanically or
electrically damaged.
Installation Instructions:
1. Before use and mounting, place the
light set on a clean, at surface and
check for any damage to the LED
lights, connections, interconnection
coupler, supply cord or adapter plug.
2. Never use sharp or pointed objects
to install / mount a string light set or
chain.
3. Fixing with metal or braided wire,
or similar devices is not advisable.
Metal or braided wire can damage the
insulation layers of the light set.
4. Suitable installation devices include
cable conduits or soft cable ties.
When using cable ties, ensure they are
not excessively tightened to the string
to avoid damage to the insulation
layers of the light set.
5. The supply cord and rope body must
not be subject to push, pull or torsion
forces.
6. Ensure a correct and secure
connection between the supply cord
and the light chain coupler, as well
as for all interconnected light chains.
The end cap of the last light set must
always be in place and tightened.
7. When connecting additional lights
to a set, make sure the Controller/
Transformer portion of the lights is not
plugged-in and powered.
8. Ensure that the light chain, supply
cord or interconnection couplers are
not located in or near running water
or drains (e.g. snow, streams, rain
gutters).
9. If the light set does not work, have it
checked by a certied technician.
Instructions for Use
Once the light set is properly mounted,
and attached to the power adapter, plug
the adapter into the appropriate electrical
outlet.
The lights should turn ON, and may
already be set to one of 8 settings,
including 6 ashing settings, one steady
setting, and one “All-in-One” setting that
cycles through all 6 ashing patterns.