Installation Guide

DETERMINING WHICH
INSTALLATION METHOD TO USE
For 6” housings:
Locate the torsion spring receiving brackets with
bottom clip. Repeat for second bracket.
For 5” housings:
Locate the torsion spring receiving brackets with
upper clip. Repeat for second bracket.
INSTALLATION
1. Remove mounting bracket and plate from inside
existing recessed housing (if installed).
2. Release socket from plate (if installed).
3. Screw Edison base adapter into existing Edison
base socket in housing.
4. Plug orange connector on Fixture into the
orange connector on screw base adapter.
5. Squeeze the torsion springs together as
shown and install into torsion spring brackets
inside recessed housing.
6. Carefully route wires into fixture and push
module up flush to ceiling surface.
1-YEAR LIMITED WARRANTY
The manufacturer warrants to the original purchaser
that the products delivered are free of defects in
material and workmanship for the period listed below
from the date of purchase.
The manufacturer requires a proof of purchase for any
warranty claim. The warranty is conditioned on the
following:
1. The manufacturer must be notified within the period
of the warranty from the date purchased and have
been given the opportunity of inspection by return of
any alleged defective product.
2. The product must not have been abused, misused or
improperly maintained, installed or repaired during
the warranty period.
3. Such alleged defects should not be deemed as a
result of any circumstance not falling under ordinary
‘wear and tear’.
4. The manufacturer makes no other warranty or
representation either expressed or implied.
The manufacturer’s maximum liability is limited to
the purchased price of the product. In no event shall
the manufacturer be liable for any consequential,
indirect, incidental, or special damages of any nature
arising from the sale or use of this product.
For questions or more information:
Visit www.novolinkinc.com or contact
Novolink Customer Service 1-800-933-7188
(9 a.m. - 5 p.m., Monday-Friday)