Use and Care Manual

1918
5. Locate the end of the wire leading from the Transformer. Place it
into the lower portion of the Connector, in the channel marked
“From Transformer”. Lead the wire completely through the
Connector. Leave the wire’s cut end bare or apply an endcap.
Ensure the wire is straight and aligned with the channel, and
rests on the brass teeth.
6. Replace the cap over this end of the wire, and press until the cap
clips into position.
Ensure the cap is turned the right direction. The caps are not
reversible. Thicker wires may be difficult to secure, and a clamp
or wrench may help squeeze or press it into place. Do not use a
hammer, as it may damage the cap.