Use and Care Manual

1716
Install the Connector
2. Locate the low-voltage wire that runs between your transformer
and the first of the landscape lights. Choose a place along the
wire in the lawn or landscaping, where the Controller’s stake can
be inserted into the ground. Here, the Connector will attach to
the low-voltage wire.
1. Unplug / disconnect your Low-Voltage Transformer. It’s best to
turn power OFF at the circuit breaker or fuse, and test that the
power is OFF before proceeding.
4. Remove the 2 caps from the top of the Controller’s Connector.
Pull up on the tabs to release the caps.
Note: the caps are designed to fit one-way on the Connector,
and won’t fit if their direction are reversed.
3. Unearth this portion of the low-voltage wire. Make sure there’s
enough slack to easily cut and manipulate the wire. Then use
wire-cutters to cut the wire here.