Instructions / Assembly

Setup
1. Download the Novolink Lightscape™ App from Google
Play (Android) or the App Store (iOS).
2. Turn OFF power to the Low-Voltage Transformer at the
circuit breaker or fuse. Test to ensure the power is OFF.
3. Assemble the Controller.
4. Locate the Controller’s Connector, and pull the tabs up
to remove the caps.
5. Choose a section of the low-voltage line between the
transformer and the first light fixture, with enough
slack in the line. Cut it here with wire-cutters.
6. Take each end of the cut low-voltage line and lead
it through its corresponding channel, marked either
From Transformer or marked To Lights, respectively.
Snap the caps back in place.
7. Plant the stake into the ground and settle the
connector above or below the ground.
8. Reconnect power to the transformer and turn it ON.
IMPORTANT: Any timers or photo-sensors must
be turned OFF, and the transformer must remain
continuously ON.
9. Open the Novolink Lightscape™ App, and add the
Controller. Assign it a zone.
Need more help? Visit: novolinkinc.com
SCAN CODE TO
DOWNLOAD APP
Download
the App
Controller
Position
Inside the
Connector
low-voltage
transformer
from
transformer
to lights