Datasheet

“main” (Installation and Administration) — 2004/6/25 — 13:29 — page 636 — #662
i
i
i
i
i
i
i
i
Figure 26.6: YaST VPN Module -– Connection Settings
This is only possible if the local IP address is already known. This means,
in the case of %defaultroute, that the default route must already be
set and the computer must already have connected to the Internet. If the
connection to the Internet is not already established when the system is
started, you can also specify that the connection should be set up and
cleared dynamically with a network interface, for example, with a DSL
interface. If the interface selected here is not the interface of the default
route, it makes no sense to enter %defaultroute as the local IP address
either. When you click ‘OK’ once, see the new connection in the connection
overview list. Click ‘OK’ again then ‘Exit’ to conclude the configuration.
26.2.2 Setting up a VPN Linux Client with FreeS/WAN
Three key steps are required to set up a VPN Linux client.
1. Create a client certificate on the CA administration computer
2. Export a FreeS/WAN configuration file
636 26.2. VPN with SUSE LINUX