Datasheet
“main” (Installation and Administration) — 2004/6/25 — 13:29 — page 18 — #44
i
i
i
i
i
i
i
i
1.7.3 Mouse
If YaST failed to detect your mouse automatically, press
Tab in the sug-
gestion window several times until ‘Mouse’ is selected. Then use
Space
to open the dialog in which to set the mouse type. This dialog is shown in
Figure 1.8.
Figure 1.8: Selecting the Mouse Type
To select the mouse type, use
↑
and
↓
. Consult your mouse documenta-
tion for information about the mouse type. After selecting a mouse type,
use
Alt -
T to test whether the device works correctly without making the
selection permanent. If the mouse does not behave as expected, use the
keyboard to select another type and test again. Use
Tab and
Enter to make
the current selection permanent.
1.7.4 Partitioning
In most cases, YaST proposes a reasonable partitioning scheme that can be
accepted without change. YaST can also be used to customize the partition-
ing. This section describes the necessary steps.
18 1.7. Installation Suggestion