Datasheet

“main” (Installation and Administration) — 2004/6/25 — 13:29 — page 116 — #142

Figure 3.3: System Information

hda: IC35L060AVER07-0, ATA DISK drive

ide0 at 0x1f0-0x1f7,0x3f6 on irq 14

hdc: DV-516E, ATAPI CD/DVD-ROM drive

ide1 at 0x170-0x177,0x376 on irq 15

hda: max request size: 128KiB

hda: 120103200 sectors (61492 MB) w/1916KiB Cache, CHS=65535/16/63, UDMA(100)

hda: hda1 hda2 hda3

If you have booted a kernel with a SCSI driver already compiled into it,

also skip loading a SCSI driver module. When detected, SCSI adapters and

connected devices announce themselves like this:

SCSI subsystem initialized

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36

aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs

(scsi0:A:0): 40.000MB/s transfers (20.000MHz, offset 15, 16bit)

Vendor: IBM Model: DCAS-34330W Rev: S65A

Type: Direct-Access ANSI SCSI revision: 02

scsi0:A:0:0: Tagged Queuing enabled. Depth 32

SCSI device sda: 8467200 512-byte hdwr sectors (4335 MB)

SCSI device sda: drive cache: write back

sda: sda1 sda2

Attached scsi disk sda at scsi0, channel 0, id 0, lun 0

(scsi0:A:6): 20.000MB/s transfers (20.000MHz, offset 16)

116

3.1. linuxrc