User Manual

8
4 GeT T ING S TA R T eD WITH THe ReMOTe ZeRO SL
4 .1 P O W eRING THe ReMOTe ZeRO SL
The ReMOTE ZeRO SL can be powered in one of three ways:
USB: Connect the ReMOTE ZeRO SL to a computer using the supplied USB cable and set the power select switch to ‘USB’.
PSU: Connect a mains PSU to the ReMOTE ZeRO SL and set the power select switch to ‘Battery/Ext DC’. The required
PSU output specs are 9V, 600-1000mA d.c., centre pin positive.
Battery: Insert four 1.5V IEC R14 (C size) batteries into the battery compartment of the ReMOTE ZeRO SL and set the
power select switch to ‘Battery/Ext DC’.
4.2 INSTALLATION - PC
The latest ReMOTE SL installer is compatible with Windows XP SP2, XP X64 and Vista (32 and 64 bit editions).
1
. Connect the ReMOTE ZeRO SL to your computer via USB and ensure it is switched on. If the Windows Found New
Hardware Wizard opens click ‘Cancel’ to close it. If you already have an older version of Automap Universal installed,
make sure the Automap Server is NOT running.
2. Double-click on ‘ReMOTESLSetup.exe’ to run the installer.
3. Whilst the driver is installing, the following message may appear:
Win XP Win Vista
Click ‘Continue Anyway’ (Win XP) or ‘Install’ (Win Vista) to continue installation.
4. Once the driver is installed, you will be prompted to select whether you have a keyboard version of the ReMOTE SL or a
ReMOTE ZeRO SL.
The installer will then guide you through updating your ReMOTE ZeRO SL with on-screen instructions. Please read and
follow these instructions carefully to ensure the unit gets updated correctly.