User Manual

76
15 T H e TeMP L AT e MeNU
This menu allows access to template settings that do not apply to individual assignable controls and are not found in Edit
mode. Press the TEMPLATE menu button to access the Template menu and edit the settings for the currently selected
template. There are two pages in the Template menu that you can scroll between using the SCROLL buttons
The first page of the Template menu is as follows:
ProgChan (Program MIDI Channel): This sets the MIDI channel on which bank and program messages are sent using the
DATA/SELECT encoder in Play mode (see section 13.1). Any assignable controls that have MidiChan set to ‘ProgCHAN’ in
Edit mode will also send messages using the Program MIDI Channel. If you change the Program MIDI Channel setting then
all controls assigned to ‘ProgCHAN’ will follow the change automatically. The range for this setting is 1-16 and ‘ComnCHAN’
(see below).
ProgPort (Program Port): This sets the port(s) on which bank and program messages are sent using the DATA/SELECT
encoder in Play mode (see section 13.1). Any assignable controls that have MidiPort set to ‘ProgPORT’ will also send
messages using the Program Ports. If you change the Program Ports setting then all controls assigned to ‘ProgPORT’ will
follow the change automatically. The options for this setting are as follows:
OFF: MIDI data is not transmitted.
U1: Sent to USB Port 1.
U2: Sent to USB Port 2.
M1: Sent to MIDI OUT Port 1.
M2: Sent to MIDI OUT Port 2.
plus the following combinations of the above:
U1 M1
U2 M1
U1 M2
U2 M2
M1 M2
U1 M1 M2
U2 M1 M2
SOFT 1 U2 U2