User Manual

73
14.6 N O T e ON/OFF (NOTe)
The Ports, MidiChan, and Name settings are the same as for Control Change (CC) so see that section for information on
these settings.
Note: This sets the MIDI note value that the control will transmit (range C-2 to G8). The Note setting will be displayed as a
MIDI note value by default but you can toggle the display format between note value, decimal and hexadecimal by pressing
the ENCODER ROW-SELECT button.
Velocity: This sets the velocity value sent with the note on message (range 0-127).
BtnType (Button Type): This is exactly as described for Control Change (CC) however the ‘STEP’ option is not available.
If this is set to ‘MOMENTRY’ then the button will send a note on message when pressed and a note off message when
released. If this is set to ‘TOGGLE’ then alternate presses of the button will send note on and off messages.
1
4.7 PROGRAM CHANGe (PROG CHG)
The Ports, MidiChan, BtnType AND Name settings are the same as for Control Change (CC) so see that section for
information on these settings.
LowProg and HighProg – These are like the Low Value and High Value settings but instead they define the Low and High
Program Change number. They should be set in conjunction with the BtnType setting as described in the Control Change
(CC) section. This way you can use a button to select a single program/patch, toggle between two different programs/
patches or step through a whole bank of programs/patches on repeated presses. Note that the ‘VELOCITY’ option for
drum pads is not available if Control is set to ‘PROG CHG’.