User Manual

60
Page 5
Power: The power source is displayed underneath ‘Power’; ‘USB’, ‘PSU’ or ‘BATT’ will be shown. The power source cannot
be set from the Global menu. Use the power select switch on the back of the ReMOTE ZeRO SL to set the power source.
BatChrg (Battery Charge): This setting allows you to charge rechargeable batteries whilst the ReMOTE ZeRO SL is being
powered from a PSU. Set this to ‘PSU Low’ to trickle charge the batteries, ‘PSU Max’ for faster charging or ‘OFF’ to turn
battery charging off.
BatVolts (Battery Volts): The voltage of any dry cells inserted in the ReMOTE ZeRO SL is displayed below ‘BatVolts’ on
the left-hand display.
Page 6
The sixth page of the Global menu is the first of two pages for calibrating the drum pads. The eight values across the
left-hand display correspond to drum pads 1-8. The pad hit velocity value is shown on the top line (‘---‘ if the pad has not
yet been hit) and the calibration value is shown on the bottom line. This first page is for full velocity (maximum
strength hit) calibration:
Hit a pad at full strength to check the current calibration. If the hit velocity value above the pad goes to 127 too easily,
decrease the pad calibration value using the encoder or buttons underneath. This will reduce the sensitivity of the pad,
meaning you need to hit it harder to reach maximum velocity.