User Manual

58
plus the following combinations of the above:
U1 M1
U2 M1
U1 M2
U2 M2
M1 M2
U1 M1 M2
U2 M1 M2
PotMode: This sets the pot response for all controls in all templates that have their individual response set to ‘GLOBAL’.
See section 14.1 for further info on pot response.
DispTime (Display Timeout): This sets the length of time that temporarily displayed information e.g. tempo/clock info,
remains on the ReMOTE ZeRO SL displays. Set the value between 0 and 1260ms, or to ‘PERM’ (permanent).
KeepVals (Keep Values): This applies to standard (non-Automap) templates. If this is set to ‘ON’ then the ReMOTE ZeRO
SL will automatically store the value of each control when you switch away from the currently selected template and
restore those values when you select that template again. If this is set to ‘OFF’ then the ReMOTE ZeRO SL will only store
control values when you manually save the template.
Midi Clk (MIDI Clock): This setting defines the MIDI clock source. The options are:
AUTO: automatic sensing of a MIDI clock source, including the ReMOTE ZeRO SLs internal clock
INTERNAL: the ReMOTE ZeRO SL’s internal clock
EXT-AUTO: automatic sensing of a MIDI clock source, excluding the ReMOTE ZeRO SLs internal clock
USB1: MIDI clock received on USB port 1, from a computer
USB2: MIDI clock received on USB port 2, from a computer
MIDI-IN: MIDI clock received at the MIDI IN connector on the back of the ReMOTE ZeRO SL
Page 3
Template Change: It is possible to use program change messages to remotely select templates on the ReMOTE ZeRO SL.
The first Template Change setting allows you to define which MIDI Channel the ReMOTE ZeRO SL will respond to program
change messages on. This can be set from 1 to 16 or to ‘ANY’. The second Template Change setting allows you to set
which MIDI ports the ReMOTE ZeRO SL will respond to program change messages on, and can be set as follows:
OFF: The ReMOTE ZeRO SL will not respond to program change messages
U1: The ReMOTE ZeRO SL will respond to program change messages sent from a computer on USB port 1
U2: The ReMOTE ZeRO SL will respond to program change messages sent from a computer on USB port 2
M1: The ReMOTE ZeRO SL will respond to program change messages received at the MIDI IN port on the back of the unit.
U1 U2 M1 U1 M1 M2 U1 M1 M2U1 M1 M2
BPMPorts
U1
IDPorts
ON
HUI