User Manual

55
7. Ensure the ‘In Port’ and ‘Out Port’ are set to ‘ReMOTE SL Port 3’, then click ‘OK’.
After following these steps you can switch between the Reason Automap template (to control Reason), the Automap
Universal template (to control Automap-wrapped plug-ins) and the Automap template for your sequencer. Remember that
you can use any of the three methods detailed in section 4.7 to switch between templates on the ReMOTE ZeRO SL.
With Reason set up to use port 3 it will still be possible to use the ReMOTE ZeRO SL with Reason when it is running in
stand-alone mode.
10.6 VJA M M
Automapping with VJamm allows instant control of the software’s main features. The basic functionality of the SL sees
the top and bottom rows of controls on the left side (buttons and trigger pads, respectively) selecting and triggering the
16 video clips in the main software window. Repeated presses of the row select buttons to the left of these two rows of
controls alternates between the two banks of 8 clips (Q-I and A-K), as shown in the diagram linked to below.
Meanwhile, the faders and top row of buttons on the right side are used to edit the currently selected clip or control the
main ‘Master’ VJ parameters, as shown in the diagram linked to below. These two modes are selected with alternate
presses of the arrow button to the right of the LCDs. The transport controls can be used to stop and play the selected clip
throughout both modes.
The pots and (in 2D mode) buttons above on the left side of the SL can also be used to edit 2D, 3D and FreeFrame
options for the currently selected clip. Simply press the row select button to the left of the row of pots repeatedly to cycle
between these three editing modes.
(Diagram on next page)