User Manual

53
The ReMOTE ZeRO SL will now automatically switch to the Reason Automap template (template 37) and will do so each
time you subsequently launch Reason. To control a Reason device from the ReMOTE ZeRO SL select it with the mouse in
the Reason sequencer, as shown here with the ‘Perc Loop’ track:
When a Reason device is selected for hardware control, the ReMOTE ZeRO SL controls will automatically be mapped to
the device parameters and you will see the parameter names and current values on the ReMOTE ZeRO SL displays. Where
the same type of parameter is found on different Reason devices it will generally be mapped to the same control on the
ReMOTE ZeRO SL e.g. filter cutoff is mapped to pot 8 for all Reason devices that have a filter.
Pressing the RIGHT-HAND SCROLL buttons whilst in Reason Automap mode causes an information display to appear on the
right-hand ReMOTE ZeRO SL display. The information shown is different depending on whether you press the SCROLL UP
or SCROLL DOWN button, as follows:
SCROLL UP: Document name, currently selected device, currently selected device parameter page, song position and
device name.
SCROLL DOWN: Tempo, loop on/off status, left loop position, right loop position and target track name.
When either information display is active you can use buttons 7 and 8 in the top right-hand row to scroll through the
available Reason devices in the project and select a different one to control, instead of using the mouse. You can also use
buttons 5 and 6 in the top right-hand row to scroll through presets on the currently selected Reason device.
Press the SLIDER ROW-SELECT button to exit the information display.
Reason devices that have lots of assignable parameters will have more than one ‘page’ of parameters available for some
rows of controls on the ReMOTE ZeRO SL. For example, when controlling ReDrum the 8 encoders can be switched
between controlling pan, length and velocity. Repeatedly press a ROW-SELECT button to cycle through the available pages
of parameters. If a row of controls has no parameters assigned to it then the ROW-SELECT button for that row will be
inactive. To see which page of controls is currently selected press the RIGHT-HAND SCROLL UP button – the page name
will be displayed under ‘Section’. The Reason devices which use multiple pages of controls are BV512, Dr. Rex, Maelstrom,
Mixer 14:2, NN19, ReDrum, ReGroove Mixer, Subtractor and Thor.