User Manual

48
In Flip mode the encoders can be used to control send panning of the currently selected send bank by pressing either the
2nd or 3rd ROW-SELECT button on the left-hand side of the ReMOTE ZeRO SL:
2nd ROW-SELECT button: Encoders control panning of a mono send, or left-channel panning of a stereo send.
3rd ROW-SELECT button: Encoders control right-channel panning of a stereo send.
To exit Flip mode and return to Track mode press the 4th ROW-SELECT button on the left-hand side of the ReMOTE ZeRO
SL once more.
Controlling Plug-ins – Insert Mode
Insert mode allows control over plug-ins in Pro Tools. To put the ReMOTE ZeRO SL into Insert mode press the 1st ROW-
SELECT button on the left-hand side (next to the upper left-hand row of buttons). The 1st ROW-SELECT LED will light when
the ReMOTE ZeRO SL is in Insert mode. You can then use the ReMOTE ZeRO SL to control plug-ins as follows:
There are in fact two modes for controlling plug-ins – ‘Insert Select mode’ and ‘Insert Edit mode’. You can switch between
these two modes using the INSERT EDIT/SELECT TOGGLE button. In Insert Select mode you can select and load plug-ins
into insert slots and in Insert Edit mode you can edit plug-in parameters.
In Insert mode the left-hand ReMOTE ZeRO SL display can show a maximum of 4 insert slots or 8 plug-in parameters at
one time. Encoders 1-4 and buttons 1-4 (above the encoders) correspond to these insert slots/parameters. The PAGE
buttons can be used to scroll through pages of insert slots or plug-in parameters.
In Insert Select mode the left-hand ReMOTE ZeRO SL display shows the insert slots of the currently selected track. There
are 5 insert slots for each track in Pro Tools but only 4 can be displayed at one time on the ReMOTE ZeRO SL so use the
PAGE buttons to access the 5th insert slot. The currently displayed insert slots (‘Insert 1-4’ or ‘Insert 5’) and the name of
the selected track are shown on the top line and the plug-in names are shown on the bottom line:
To edit the inserts on a different track press and hold the INSERT (LEFT-HAND SCROLL UP) button. You will see
abbreviated track names on the left-hand ReMOTE ZeRO SL display (as in Track mode). Press the button in the upper left-
hand row on the ReMOTE ZeRO SL that corresponds to the track whose inserts you want to edit and THEN release the
INSERT button. You may need to press the BANK UP/DOWN buttons whilst INSERT is held down to scroll through banks of
tracks and find the track you want. You can also select a track for insert editing in this way when the ReMOTE ZeRO SL is
in Track mode or Flip mode - the ReMOTE ZeRO SL will then automatically switch to Insert mode.