User Manual

39
10 SeQUeNCeR AUTOMAP
This section contains set up instructions for all sequencers that use Sequencer Automap.
1 0 .1 L O G I C
Setup
To set up Logic Automap, carry out the following steps:
1
. Make sure you have Logic 7.1 or later. Logic 8 is also supported.
2. Connect the ReMOTE ZeRO SL to your computer, turn it on and launch Logic.
3. In Logic go to Preferences -> Control Surfaces -> Setup...
4. Select ‘Scan All Models...’ from the ‘New’ menu.
5. The ReMOTE SL should be automatically detected. A message may appear saying that some models cannot be
scanned. Click ‘OK’, then click ‘Done’ (Logic 7) or close the ‘Install’ window (Logic 8).
6. Click on the ReMOTE SL in the Control Surface Setup window to view it’s settings (on the left-hand side of the window).
Ensure the Input and Out Port are set to ‘Port 2’. Note that if you have any other MIDI interfaces or USB MIDI devices
their ports will be listed as ‘port 1’, ‘port 2’ etc. so make sure you have the correct ‘port 2’ selected.
7. Open the Logic Environment and select the ‘Clicks & Ports’ page from the drop-down menu on the left-hand side
of the window.
8. Logic Pro only: Select ‘Monitor’ from the ‘New’ menu to create a Monitor object and connect both port 2 and port 3
of the ReMOTE SL to it from the Physical Input, as shown: