User's Manual
Table Of Contents
- 6.5 Overlap
- 6.5 Overlap
- 6.5 Overlap
- 1. Introduction
- 2. Getting Up and Running
- 3. Hardware Overview
- 4. Launchpad Pro Interface
- 5. Session Mode
- 6. Note mode
- 7. Chord Mode
- 8. Custom Modes
- 9. Sequencer
- 10. Setup
- A. Appendix
- A.1 Default MIDI mappings
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.1.2 Custom 2: 8x8 Grid, 8 Horizontal Bipolar Faders, CC numbers below
- A.1.3 Custom 3: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.4 Custom 4: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.5 Custom 5: 8x8 grid, Program Change messages
- A.1.6 Custom 6: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.7 Custom 7: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.8 Custom 8: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.9 Programmer Mode: Includes buttons and pads (full 9x9 grid), logo LED may be addressed, Momentary Note On messages (note numbers below)
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.2 Overlap Layouts
- A.1 Default MIDI mappings
58
10.8 Bootloader Menu
Launchpad Pro’s bootloader menu allows you to change LED brightness, LED feedback, mass storage
device availability, and device ID.
To enter the bootloader menu, hold Setup when plugging in Launchpad Pro.
10.8.A Bootloader menu view
The LED brightness level slider has 8 levels, from minimum to maximum brightness. The brightly
lit white pad indicates which level is currently selected. Certain USB host devices may not provide
sufficient power to fully boot Launchpad Pro. The power consumption may be reduced by using lower
brightness levels, allowing these devices to fully boot Launchpad Pro.
Use the Bootloader Version and App Version pads to view what is currently installed on Launchpad
Pro.
Pressing the Boot-up button will start Launchpad Pro normally, exiting the bootloader menu.
Device ID allows you to use multiple Launchpad Pro units with Ableton Live at once. When different
ID values are selected on each Launchpad Pro, they will each have their own Session View outline and
thus can navigate the Live session independently.
MSD Mode toggles the mass storage device behaviour of Launchpad Pro on or off. Once you’re set
up with Launchpad Pro you may no longer want it to appear as a mass storage device. Use this toggle
to disable the behaviour completely. When the pad is brightly lit MSD mode is enabled, and it is dimly
lit when disabled.