User Manual

English

Using batteries

Circuit will also operate from six AA-size R6 Alkaline or high-capacity Lithium batteries. A set of

suitable batteries is supplied.

The battery compartment is on the right-hand side of the unit. Slide the compartment cover

downwards to open it; note the cover has a retaining strap.

Slide cover down

too reveal battery

compartment

Insert the batteries in two sets of three, as shown by the diagram on the base of the unit

immediately below the battery compartment:

+ - + - + -

Shift

Patterns

Mixer

Notes:

• Circuit will accept both 1.5 V non-rechargeable and 1.2 V NiMH rechargeable batteries

in AA-size. In the case of non-rechargeable batteries, we recommend the use of either

Alkaline or high-capacity Lithium types.

• Never mix battery types. Always ensure that all six batteries are of the same type.

• Battery life is dependent on type: up to ve hours use should be obtainable from high-

quality Alkaline types.

• Circuit does NOT charge rechargeable NiMH cells while installed; these must be

recharged externally in a suitable charger.

• Do not mix cells that are charged to a different degree – i.e., don’t mix brand new cells

with partially-run-down ones.

• Always remove batteries from your Circuit if it is not to be used for a long period.

• Spent batteries contain hazardous substances and should be disposed of in a responsible

manner. Always dispose of used batteries in accordance with local environmental and/or

recycling guidelines.