User Guide

83
English
Matrix assignment
The Modulation Matrix supports up to four modulating sources to be routed simultaneously to
up to eight controlled destinations. This implies 32 possible assignments, each with a different
level or “amount” of control.
The four modulating sources available are:
• Env – the output of the envelope generator
• LFO – the LFO output
• Seq – the modulation sequence
• Vel – velocity
The eight destinations available for control are:
• Pitch – Oscillator 1 Pitch
• Pitch – Oscillator 2 Pitch
1
• PWM – Oscillator 1 Pulse Width
2
• PWM – Oscillator 2 Pulse Width
1,2
• Amp – VCA level
• Filter – lter frequency
• Dist – post-lter distortion amount
• Aux CV –DC voltage at the AUX CV output
NOTES:
1. Pitch and PWM are active for the Oscillator currently selected by Osc 1 and Osc 2 buttons
5
.
2. Oscillator waveform must be set to Square/Pulse for PWM to be active.
40
38
39
The Depth control
40
determines the degree of control that the selected source has over the
selected destination. It is a “soft” control, in that it sets the control level for the particular matrix
routing currently dened by the settings of the Source
38
and Destination
39
buttons. Each of
the 32 possible routings can have its own level. The currently selected Source is indicated by
the LEDs above the button and the currently selected Destination by the LED in the Destination
buttons – only one LED will be lit in each case. The LEDs in the Pitch and PWM buttons will
light in the currently selected Oscillator’s characteristic colour.
The Depth control’s LED illuminates at a brightness proportional to the control level for the
currently selected matrix routing.