User Guide
20
English
BASICS
Powering the unit on
Circuit Mono Station must be powered from the supplied AC adaptor. Connect the adaptor to
the DC input socket
10
and plug the adaptor into the AC mains.
Connect the main output to a monitoring system (powered speaker or a separate amplier and
passive monitor) or, if your prefer, plug in a pair of headphones at the front of the unit.
Long-press the Power button
10
to turn Circuit Mono Station on: this will re-load the Session
that was in use last time the unit was on. The rst time you power the unit “out of the box”, this
will be Session 1, which is the rst of the 16 demo Sessions that were loaded at the factory (see
“Getting started” on page 21).
Circuit Mono Station always starts up in Note View, with Osc 1 selected as the displayed Track.
The grid display will look something like this:
Blinking Cyan/White
Pad
You can override the automatic re-loading of the previous Session at power-
up by holding down the Shift and Clear buttons while pressing the Power
button*. This will load the Init Patch instead.
* on software versions 1.1 or later