Prerequisites Procedure Step 1 Step 2 Step Step Step § Steps Chick Configuration * LED screen must be a regular screen. * Cabinets of the screen must be regular cabinets with the same resolution + The following data flow settings are supported. During data flow sittings, ensure that the physical connection of each port is along the same direction and downward to next one.
Layer Operations Add Layers Step 1 On the device grant panel, locate and press the desired layer button in the CONTROL area, and then the button becomes flashing and the device screen displays the layer settings screen Step On the layer settings screen, rotate the knob to ast the layer status to On toads a layer. You can also add a layer via menu operations.
Switch Layer Input Sources The VX400 offers two ways to switch the layer Input source + Via menu operations Via front panel buttons + Vis many preparations on the teen, go to Layer Settings > Main PlayStation > Input Source, and then elect the desired source and press the knob to confirm + Via front pane buttons Step Ont he device front panel, locate and press the desired layer button In the CONTROL area, and than the button becomes flashing and the device screen displays the layer tastings screen Step 2 Pr
Pr asst Operations The VX400 supports up to 10 user-defined sprat. You can save the layer layout, Input source and mare Info ac a preset for future uss Save Presets Prerequisites You have completed the layer size, position and related settings. Procedure Step 1 On the main menu screen, go to Pres st Settings > Preset 1 to open the preset operations window: Step Rotate the knob to select Save and pass the knob to confirm + Save: Save the current layer settings to a specified preset.
Backup Operations The VX400 supports three kinds of backup, Including the device backup, Ethernet port backup and Input source backup. Devices Backup The connection diagram for device backup Is shown In below. After the hardware connections are completed, go to Advanced Settings > backup on the main menu screen, and then set the devices as the primary and backup devices respectively.
Hammett Port Backup When setting the backup between the Ethernet rts, you ends to Nova CT. The connection diagram ls shown on tha right. ‘Control PC: Log into Covalent, and then go to Screen Configuration > Sending Card. Under the Sending Card tab, seethe backup between Ethernet ports In the Redundancy area. Step Click Add to open the Redundancy Settings window.
input Source Backup ‘When the Input source hot backup function Is turned on, If an Input source falls, Its backup source will bis used seam essay to ensure the screen wil nat go black On the main menu screen, go to Advanced Settings > Input Backup to enter the input source backup screen. Step 1 Rotate the knob to turn on the Input source backup function. On tha left are the default input sources, and on the right you can sett ha backup sources.
( Working Mode The VX400 supports three Kinds of device working modes: Ids Controller default), Fiber Converter and Byes * Video Controller: The device works as an all-in-one controller offering * Fiber Converter: both the video processing and control capabilities. in this mode, OPT 1 Is used for either the Input or output, and OPT 2 backs up or capes the output an the Theme ports. he device Is used for long-distance transmission.
