User Manual

ET2000 Multimedia Control System
User Manual
www.novastar.tech
49

Not occupied: The TCP/IP control settings are completed.
6.4.2 Control via Serial Port
To control Kompass FX2 via serial port, use a serial cable to connect the control device to the computer where
Kompass FX2 is installed.
Step 1 Go to Settings > External Control > Serial Port to open the window shown in
Figure 6-4.
Figure 6-4 Serial port control
Step 2 Click Scan. The system will automatically scan the serial ports of the computer.
Step 3 Click the drop-down box next to Serial Port and select the serial port currently connected to the control
device.
Step 4 Set Baud Rate, Data Bits, Parity, and Stop Bits.
Note:
The parameter values of baud rate, data bits, parity and stop bits of the serial port on the control device must
be the same as the values of those parameters you set in Kompass FX2.
Step 5 Click Open Port to finish serial port settings.
Step 6 Click Close to close the External Control window.
6.4.3 Control via App
Kompass FX2 built in a media server can be controlled via an App named Visual Centralized Control Platform
(VCCP). The connections for App control are as follows.
XI'AN NOV ASTAR TECH CO., LTD.