User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
53
2. If the support structures have been generated in a different program than NovaMaker,
make sure that the model’s mesh is fixed and the raft properly adheres to the platform.
3. Make sure that the print has been properly prepared in NovaMaker, that is, its size and
plane dimension are within the print range. Each layer that should be parallel to the platform,
proper support size not too small to ensure successful printing.
4. Make sure that while preparing the file in NovaMaker you chose an appropriate
printing profile, that is, the print settings match the type of used resin. If the profile is correct,
enable Additional support exposure time option and decrease the Platform lift speed in the
Parameter setting menu.
5. Check if the FEP film is not bent, deformed, or perforated. Replace the FEP film if you
notice such defects.
6. Contact the Support Center at: http://www.nova3dprinter.com/docs/index.html