User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
49
NOTE! It is advisable to filter the already used resin after each print. Mix it with the fresh resin
to make sure that there are no cured remains in the liquid, as they could have a negative
influence on the quality of the next print and shorten the resin lifespan.
1. Clean the resin vat with a paper towel. You can also use alcohol for that purpose.
2. Clean the platform, LCD screen and the resin vat. After that, install the resin vat back into
the printer and fasten the spherical button on both sides to fix it.
3. Fill the vat with new resin.
4. Install the UV cover back on the printer.
11. Available Materials
The complete offer of materials is available at:
http://www.nova3dprinter.com/material.html
Material Technical Data Sheets and Safety Data Sheets can be found at the same website.
When 3D printing with the Nova3D BENE4, the Manufacturer recommends using
Nova3D
certified materials, ensure that the resin packaging is intact and to check whether the resin is
within its lifespan to acquire the best possible quality of prints.