User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
47
c. Post-Processing
1. Wear safety gloves and use a cutting knife to carefully remove the model from the platform.
Then clean it with high concentration of industrial alcohol (above 95%) and blow-dry the
surface alcohol. The cleaning is finished until the surface of the model is dry without oily.
Otherwise, follow the steps above to continue cleaning and blow-drying. Be careful not to
expose the model to the UV light before cleaning.
2. Put the model in the Curing box or in any source of UV light (e.g. direct sunlight).
Depending on the type of resin you’ve used for printing and the application requirements, this
step is optional.