User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
44
b. Starting
Remove the UV cover, fill the vat with resin, then install the UV cover back on the printer.
1. Transfer the file from NovaMaker to the printer (via Wi-Fi /Ethernet or using the USB drive)
and start the printing process. Transfer files from NovaMaker to the printer via WIFI or
Ethernet. Enter the device management interface and click to open the file, select the
sliced .CWS file in the computer, it will be displayed in the list after uploading, select the file
just uploaded and choose to start printing