User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
43
10. Starting and Post-Processing
Caution!
Wear gloves and glasses during all procedures!
Printing and post-processing waste, including empty bottles, failed prints, supports, rafts
as well as paper towels with resin residues should be put in the UV Station or in any source of
UV light before disposal. Uncured resin has to be disposed of in accordance with national and
local regulations concerning hazardous waste.
a. Preparation for Printing
Check the LCD screen for proper operation
Remove the platform (as shown in the picture below), loosen the fixed knob above the platform,
and hold the top of the platform with your hand to pull it out .Click the "Settings" of the home
page, enter the "LCD Screen Check" , and then check the LCD screen for proper operation
according to the prompt.