User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
39
Parameter configuration is required before slicing. Even for the same model, different
parameters need to be set if printed with different resin materials.
The default parameters are grayed out and cannot be changed. Click on “clone”. The
cloned data can be modified corresponding to the material used. (Setting steps as shown below)
4.2．Parameter Setting Considerations
（1）When printing with BENE4, check the slicing software version at the upper left, the
version needs to be above 2.4.2. If the version is below 2.4.2, please contact customer service
to provide the latest software version.