User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
33
（2）Default Print Parameters for SLC: When printing with a .cws file, the parameters are
generally defaulted and do not need to be changed. If you need to adjust the parameters, please
contact Nova3D after-sales engineers for technical support.
Exposure Time (ms): set the exposure time of each layer
Bottom Layers: set the number of bottom layers
Bottom Time (ms): set the exposure time of bottom layers
Lift Distance (cm): control the lift distance of the platform after a layer is printed
Lift Speed (mm/min): control the lift speed of the platform
1.2.4
．
Setting
Users can read printer information including: WiFi network configuration, wired ethernet
IP, hardware information, upgrades, etc.