User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
19
6. Connecting the Printer to a Network
Nova3D BENE4 can be connected to a local network in two ways: via Wi-Fi or an
Ethernet cable. Both methods allow you to manage the printer directly from NovaMaker and
make it possible to remotely transfer .cws files from your computer to the printer.
To connect the printer with an Ethernet cable:
Plug the cable to the port of the device and plug the other end of the cable to the network
interface of the computer or network adapter . Open NovaMaker software, click the icon on the
right side of the title bar to enter the printer management interface, then click the "+" on
the upper right side to display the pop-up box of "printer add guidelines", select the first item
(the printer has not done network configuration...) and then proceed until prompted to add the
printer successfully.
To connect the printer to a Wi-Fi network