User Manual
Table Of Contents
- Introduction
- General Safety Information
- 1. Learn More About the Nova3D BENE4
- 2. What’s in the Box
- 3.Main Components
- 4.Nova3D Printing Technology Glossary
- 5.Preparation before use
- 6. Connecting the Printer to a Network
- 7. Firmware Update
- 8. Navigating Through the Menu
- 9. NovaMaker Software
- 10. Starting and Post-Processing
- 11. Available Materials
- 12. Basic Maintenance and Service Work
- 13. Support and Troubleshooting
- 14. Specification
- 15. Recycling
深圳市诺瓦机器人技术有限公司
Shenzhen Nova Robot Technology Co., Ltd.
16
5. Preparation before use
Open the box and remove the upper cushioning.Remove the UV cover.Take the printer out
of the box.
3D Printer Assembly
1. Align screw holes on the back of the UV case with the ones on the 3D printer’s back.
2. Take the srews out from the pack and get them installed then peel off this tip.
Calibration
1. Take out the buffer cotton between the platform and the screen, tear off the protective