Baby Unit Parent Unit
Congratulations! Thank you for choosing the SuperNOVA Digital Babycall, model FD-D3. This is a quality product developed for optimal safety and comfort, based on new, sophisticated technology. An electronic babysitter can never replace parental care for a child, but it is a practical aid that will ease your worries. Please read this user manual carefully and keep it in a safe place. Quick start 1. Install the battery packs (11) in the baby unit and the parent unit.
Parent Unit B1 Telescopic antenna .... should be pulled out when unit in use B2 Light indicator ............ blinks every six seconds on standby; blinks rapidly when activated B3 On/Off button ............. switches power on or off B4 LCD display ................ shows all information about the unit's status B5 ▲ key .......................... key for increasing volume programming function for selecting channel and digital code B6 R key ...........................
Note: If the battery symbol blinks in one unit and you hear an alarm every 5 –10 seconds, this means the battery must be recharged to continue operation. The parent unit also gives a signal to indicate a weak baby unit battery but the sound is softer. The battery symbol then blinks only on the baby unit. Detailed instructions 1. The baby unit and parent unit must be set to the same channel, A or B. If the units do not display the same channel, the channel on one of the units must be switched.
When you press the R key on the parent unit you disable all coding for three seconds. This enables you to listen to the channel if there is any traffic on it.
If this does not help there is nothing that can be done about it, but it was nevertheless sounds from your child that first activated your parent unit, so you have not been wrongly signalled! Interference during transmission may thus be expected because units within a certain area will often use the same frequency. When your SuperNOVA is on standby you will not be disturbed by other baby monitors unless they are adjusted to the same code and the same channel, in contrast to other brands.
TROUBLESHOOTING CHART Problem Possible cause Solution The indicator (2) does not light up. The display goes out shortly after the unit is switched on. The unit is not switched on. The batteries are discharged. The charging indicator (13) on the charger does not light or blinks red. Poor contact between the unit and the charger. Press the On/Off button (3). Recharge the batteries while the unit is turned off. Remove the batteries for 30 seconds before switching the unit on.
