Parent unit B1 On/Off button . . . . . . . . . . . . . . Switches power on or off B2 Channel indicator. . . . . . . . . . . Shows the channel that has been set. Blinks when the unit is in standby mode and remains on constantly when it is activated B3 Low battery indicator . . . . . . . . Blinks when the battery is drained B4 Range indicator . . . . . . . . . . . . Blinks if there is no contact with the baby unit B5 Volume indicator . . . . . . . . . . . Blinks to show sound level when the unit is activated.
M V V M V V M V V Baby unit 1. Adjust the channel Press the M button once, A or B blinks rapidly. Select the desired channel A or B using the ▲ and ▼ buttons. Then press the M button to store. The unit now returns to normal operations. 2. Adjust sound sensitivity Press the M button and hold until the sensitivity indicator lights. Adjust desired sensitivity using the ▲ and ▼ button. More arcs indicate higher sensitivity (one light = low, two lights = medium and three lights = high sensitivity).
it was after all sounds from your child that activated your parent unit, so you have not been alerted unnecessarily! Distortion during transmission may thus be expected because units in the same area normally use the same frequency. This is not a problem when your PrimaNOVA is on standby: You will not be disturbed unless another PrimaNOVA has been adjusted to identical codes and channels, in contrast to other baby monitors.
Troubleshooting chart Problem Possible cause Solution No indicators are displayed. The unit turns itself off shortly after the unit is switched on, or the unit cannot be switched on. The unit cannot be switched on. The unit is not switched on. The batteries are discharged. Press the On/Off button (A1, B1). Recharge the batteries while the units are turned off. Remove the batteries for 30 seconds then switch the unit on. Charge the batteries.
