Instruction Manual

Page 17 of 48

9.4.2 Percent Weighing

Percent weighing will be done by defining a certain weight to be 100%. The

weight to be used can either be entered by the user or taken from a sample

• Press [Mode] and then the [Up] or [Down] key to select Percent

weighing, “PERCENT” will be displayed

• Press [Enter] to enter the function

• Display will show, “PERCENT SAMPLE”

• Press [Enter] to select the sample method or skip to manually enter the

sample weight as given below

• When “LOAD 100 %“ is shown, add the sample

• Press [Enter] to set this weight to be 100%. The display will show “REF

WT” and the sample weight in the last selected unit. After a while

“100%” will be displayed. A message “PERCENT” will be prompted on

the top of the display to indicate that the balance is in the percent

weighing mode

• Remove the sample and “PERCENT 0.00%” will be displayed

• Place an unknown sample to display the percentage weight

• To set another weight as 100%, press [Mode] and continue as before

• To manually enter a value to be set as 100%, press [Up] or [Down] key

when “PERCENT SAMPLE” is shown to select “PERCENT Ent Wt”

• Press [Enter]. Display will show the value in the unit, last used in the

weighing mode

• Enter the weight using the numeric entry method (see section 7.1).

• Place unknown sample to display the percentage weight

• To perform percent weighing with another sample press [Mode] and

continue as before

• To return to normal weighing, press [Esc]