Instruction Manual

2) To recall data from memory, press . The location of the most recent
stored data is displayed first. Press
or to select the location of
the desired data, then press to accept.
3) Press
to return to the stored data location. Press to return to
measurement mode. To erase stored data, see Section 5.8.
5. SETUP FUNCTIONS
Use the set up mode to customize your instrument operation. During
measurement, press and hold
for 5 seconds to enter SETUP mode.
Press
or to change programs or change options.
Press
to select the program or confirm selection.
Press
to go back a level or to return to measurement mode.
5.1 P1.0 CAL (Calibration)
Press
to view each stored calibration point.
5.2 P2.0 ELE (Electrode Information)
Press
to view mV offset (OFS) in mV and pH modes only.
Press
to view % slope (SLP) in pH and Ion modes only.
Electrode Property
Last Display
Mode
Offset Slope
pH in mV %
Ion - in mV
mV in mV -
8