User Manual

Page 32 of 44
Format of custom forms #1 and #2
If FORM1 or FORM2 is selected, it can be changed by the user using a
selection of available data. By default the 2 forms are the same as the
standard form unless changed by the user as below.
When FORM 1 or FORM 2 is selected the user can set the information to be
printed on each line of the form. Pressing the [Up] or [Down] keys will cycle
through the options available. The options are:
INST ID Instrument ID number
SER No Serial Number
TIME Time
DATE Date
NET Net Weight (Gross weight – Tare Weight)
GROSS Gross Weight
TARE Tare Weight
UNIT Unit weight in parts counting mode
COUNT Number of items in parts counting mode
REF 100% weight in percent weighing mode
PERCENT Percentage of reference weight in percent weighing
LO LIMIT Low Limit when check weighing
HI LIM High Limit when check weighing
Cr Lf Inserts a blank line
END Signifies the end of the report
When END is entered the display returns to the RS-232 Sub-menu
Enter the data to be printed on the first line by pressing the [Up] or [Down]
key to cycle through the options. If the current information is OK then press
the [Setup]/Enter key to move to the next line.
e.g. “LINE No1” “DATE” - prints date
Select a code for one of the preset data formats as detailed above.
The next line shows: “LINE NO 2” “TIME” - prints time
Only one item can be entered per line.
Continue until the formatting of the form is complete. There are 15 lines of
possible data. After the 15
th
line has been set or “END” has been selected,
the balance will return to the RS-232 Sub-menu.
Press [Mode] to advance to setting of the next menu or press [Esc] to return
to normal weighing.
© Adam Equipment Company 2007