Manual
12.6 PASSCODES
To enable the security features in this balance it is necessary to set passcodes.
There are 2 passcodes called Operator Passcode and Supervisor Passcode. The
Operator Passcode allows an authorised user to operate the basic weighing
functionsofthebalancebutwillnotallow accesstotheSupervisorMenusifthe
SupervisorPasscodehasbeenset.
To change or disable a Passcode it will be necessary to enter the current
passcode.
Press[Enter]when“PASSCODES”isdisplayedtoenterthissection.
SelecteitherOperatororSupervisorpasscodeusingthe[Up]or[Down]keys.
Press[Enter]toselectthepasscodetochange.
Press[CAL]toenterthecurrentpasscode(OLD)firstthenenteranewpasscode
if desired.Use the numeric entry method (see section5.1).A passcode set to
zerowilldisablethesecurityfeatureandallowunlimitedaccess.
ForgottenPasscodes
Keep a record of the passcode to ensure you can access this section again.If
however you have forgotten your passcode you can still gain access by entering a
universalcode.
Ifyouhaveforgottenthecurrentpasscode a code of “15” will always allow youto
entertheSupervisorarea.
UsingtheSupervisormenusgo to the PASSCODE section andresettheoperator or
Supervisorpasscodeusingthe“15” codeastheoldnumberwhenasked.
35 | Page © Adam Equipment Company 2008