Manual

12.0 SUPERVISORMENUS

Pressingthe[Setup]keywhileinnormalweighinggivesaccesstothemenus.

1) When [Setup] is pressed and passcodes are not enable the display will show

themessage“SUPERVISOR”.Ifpasscodesareenabled,thebalancewillaskfor

itbydisplaying“PASSCODE 0”

2) Ifawrongcodeisenteredan “ERROR CODE” messagewillflashandthebalance

willreturntoweighingmode

3) If the passcode has been enabled and entered, the balance  will allow the

operatortoaccesstheSupervisor’smenus

4) When the display shows “SUPERVISOR” press [Enter] to view the topics that

canbemodified

5) From this menu the user can enable/disable weighing units or modes, set

balanceparametersfortheconditions,settimeanddate,setparametersfor

theRS‐232interface,calibrationparametersandsecurityparameters

6) The[Up]and[Down]keyswillcyclethroughthemainheadings,pressingthe

[Enter]keywillentertheheading andsub‐parameters oroptionscan beset.

Press [Mode] to  come out of a sub‐menu or to  [Esc] to return to normal

weighingfromanymenu

12.1 ENABLEWEIGHINGUNITS

1) When“UNITS”isdisplayed,press[Enter]. Thedisplaywillshowthesymbolfor

thefirstunit,e.g. kilogram, kg, togetherwithitsenablestate“OFF” or “On”.

Theuser canthenenable ordisablethe caratsunitby using [Up]or[Down] .

Pressing[Enter]willconfirmthesettingandwilladvancetothenextweighing

unit.Repeatforeachweighingunitinturn.Gramisalwayssetto“On”

2) Press[Mode]toadvancetosettingofthenextmenuorpress [Esc]toreturn

tonormalweighing