Manual

12) Placeunknownsampletodisplaythepercentageweight

13) To perform percent weighing with another sample press [Mode] and

continuefromstep2above.

14) Toreturntonormalweighing,press[Mode]thenpress[Esc].

Note:Percentagewillbedisplayedto themaximumnumberofdecimalplacesbased

on the resolution of the balance. To increase or decrease by one decimal place,

pressthe[Up]or[Down]keyrespectively.

7.3 CHECKWEIGHING

Duringweighingofasamplethebalancecanbesettoshowiftheweightisaboveor

below an upper and a lower limit.The display will use the arrows under the fill

guidetoshow thecheckweighing is operating.Thearrowsand barsbetweenthe

arrowswillindicatewhentheweightisbelowthelowerlimit,betweenthelimitsor

abovetheupperlimit.

Thebuzzercanbesettobeactivewhentheweightisoutsidethelimits(belowthe

lowerorabovetheupper)orwithinthelimits(abovethelowerandbelow theupper

limit),orturnedoff.Ifdesired,onlyonelimitneedstobeset.Ifonlyonelimitisset

theotherlimitisconsideredtobezero(lower)orthemaximum(upper).

TheCheckweighingisnotactivefromzeroto20scaledivisionshoweverthearrows

willstillbeturnedonbelowthefillguideandtheweightwillstillbedisplayed.



Steps:

1) Press[Mode]andthenthe[Up]or[Down]keytoselectCheckWeighing.When

“CHECK”isdisplayedpressthe[Enter]keytoenterCheckWeighingmode

2) Press[Up]or[Down]tosetthe “LOW LIMIT”to“On”or“OFF”

3) Press [Enter] to proceed.If the “LOW LIMIT” was set to “On” the display will

showthe currentlowlimitand allowyou tochange thelimitusingthe numeric

entry method (see section 5.1). The display will show the weigh in the current