Manual

8) Duringpartscountingcheckswillbemadetodeterminethattheweightofthe

reference parts is large enough for reasonably accurate counting (weight of

eachpieceshouldbe>1d)

7.2 PERCENTWEIGHING

Percent weighing will be done by defining a certain weight to be 100%.The

weighttobeusedcaneitherbeenteredbytheuserortakenfromasample.

Steps:

1) Press [Mode] and then the [Up] or [Down] key to select Percent weighing,

“PERCENT”willbedisplayed

2) Press[Enter]toenterthefunction

3) Displaywillshow,“PERCENT SAMPLE”

4) Press [Enter] to  select the sample method (see step 5) or press the [Up] or

[Down]keytoselectthemanualentryofweightmethod(seestep9).

5) When “LOAD 100 %” isshown,addthesample

6) Press [Enter] to set this weight to be 100%, the busy symbol will turn on.

Whenreadythedisplaywillshow “100%”

7) Removethe sampleandplaceanunknownsample todisplaythe percentage

weight

8) Tosetanotherweightas100%,press[Mode]andcontinuefromstep2above.

9) Tomanuallyentera valuetobesetas100%,press[Up]or[Down] keywhen

“PERCENT SAMPLE”isshowntoselect“PERCENT Ent Wt”

10) Press[Enter]toselectthemanuallyenteredweightmethod

11) Entertheweightusingthenumericentrymethod(seesection5.1)