Manual

6.2 PASSCODES

If a passcode has beenset to limit access to the weighing functions of the balance

the display will show “PASSCODES” with the main digit set to zero.The display will

changetoshow7digitssettozerowiththerightmostdigitflashing.Usethenumeric

entry method (see section 5.1) to enter the code. Make sure to enter the correct

passcodetocontinue.SeetheSection12.6fordetails.

6.3 WEIGHING

1) Press[→0/T←]tozerothebalance,ifrequired,“→0←”willbedisplayed

2) Placeamassonthepanandtheweightwillbedisplayed

3) If a  container is used press [→0/T←] to tare the balance (zero the display)

when the stable symbol “~” is on. “Net” will be displayed to indicate that the

balanceistared

4) When the display shows zero, place the item to be weighed.  Only the net

weight will be displayed. The capacity tracker at the bottom of the LCD will

indicate the weight graphically with respect to the maximum weighing

capacity

5) Atanytimethe[Unit]keycanbepressedtoselectanotherunit.Usethe[Up]

or [Down]  key to scroll through the units and select the desired unit by

pressing the [Enter] key, the display will change to show the weight in the

selected weighing unit. The available weighing units can be enabled or

disabled by the user (see section 12.1). Only weighing units that have been

enabledwillbecycledthroughwhenthe[Unit]keyispressed